PRECIS support forum http://forum.precisrcm.com/ |
|
Running Precis v2 with new LBCs http://forum.precisrcm.com/viewtopic.php?f=1&t=96 |
Page 1 of 1 |
Author: | luisblacutt [ Fri Jun 10, 2016 2:04 pm ] | ||
Post subject: | Running Precis v2 with new LBCs | ||
Hi all I'm running Precis v2 for the first time after successfully performed the control run. Now that I have the new RCP boundary conditions I'm not able to run any experiment Attached is my leave file Best regards Luis
|
Author: | dmhg [ Mon Jun 13, 2016 2:00 pm ] |
Post subject: | Re: Running Precis v2 with new LBCs |
Hi Luis, You have two choices Choice 1 (I recommend): Download the May 2016 release of PRECIS 2.0 and install it over the top of your current version http://www.precisrcm.com/PRECIS/Precis_vn2.0.0.zip After installing it, try your experiment again by typing Code: restart agzab NRUN and see what's happening by typing Code: runtime agzab Remember the model always stops at the end of the first model month. Choice 2 (quick solution): open the file file $UMDIR/vn4.5/ctldata/ancil_config/akwss change two lines source_sst=HadGEM2-ES_historical_sst_ to: source_sst=HadGEM2-ES_historical_sst source_sice=HadGEM2-ES_historical_seaice_ to: source_sice=HadGEM2-ES_historical_seaice Save the file and exit (Do the same for akwsa, awksl, akwsx if you use future HadGEM2-ES) Now try to run PRECIS again. David |
Author: | luisblacutt [ Mon Jun 13, 2016 3:27 pm ] |
Post subject: | Re: Running Precis v2 with new LBCs |
Dear David, Thanks for your prompt response, I took the choice #2 for a quick view (and it is apparently working). Anyway I'm downloading the new v2 of Precis. How do I procced?, just install as the first time? or, do I have to delete some files? Best Luis |
Author: | dmhg [ Fri Jun 17, 2016 2:39 pm ] |
Post subject: | Re: Running Precis v2 with new LBCs |
Hi Luis, You can just install it over the top of the current PRECIS installation, although I would recommend stopping (cleanly) any run that's going, and then restarting it after the upgrade. David |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |