| PRECIS support forum http://forum.precisrcm.com/ |
|
| CRUN finished too often http://forum.precisrcm.com/viewtopic.php?f=1&t=82 |
Page 1 of 1 |
| Author: | larrychou [ Sat Apr 09, 2016 7:05 am ] | ||
| Post subject: | CRUN finished too often | ||
I am running an experiment through using PRECIS 2.0, but there is a problem. The experiment always has been stopped and display CRUN finished, and then I need to manually restart it.
|
|||
| Author: | dmhg [ Sat Apr 09, 2016 10:21 pm ] |
| Post subject: | Re: CRUN finished too often |
Hi Larry, There's a sticky post on this forum "rerun as NRUN". Try following the instructions there to see if it makes any difference. Thanks David |
|
| Author: | larrychou [ Sun Apr 10, 2016 4:02 am ] |
| Post subject: | Re: CRUN finished too often |
Dear David, Thanks so much for your prompt reply. I took a look at the sticky post on this forum, but it wasn't like the problem I described here. I am running an experiment over a region from 1959 to 2005. The experiment will be stopped at points (e.g., 1959/12/1, 1959/12/11, 1960/1/1, 1960/1/21, 1960/2/1, 1960/2/1, 1960/2/21, 1960/12/21, 1961/1/1, 1961/1/11, 1961/1/21/ 1961/2/1, 1961/12/11, and so on). These points can be referred to MWLE in the leave file. It seems that the experiment will be stopped at these dates every year (e.g., 1959, 1960, 1961,...). After the experiment has been stopped, I can restart the experiment without any problem. However, I need to manually restart the experiment at these dates every year. I need to check the experiment every day and the historical simulation already took a lot of time. I am thus wondering if there is a problem regarding the experiment and how i could solve this problem in order to finish the experiment faster. Thank you very much for you help. Regards, Larry |
|
| Author: | dmhg [ Thu Apr 14, 2016 8:43 am ] |
| Post subject: | Re: CRUN finished too often |
Hi Larry, We've sent you some questions offline that should help us get to the bottom of the issue. David |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|
