PRECIS support forum
http://forum.precisrcm.com/

error message
http://forum.precisrcm.com/viewtopic.php?f=1&t=50
Page 1 of 1

Author:  gkebede12 [ Tue Nov 11, 2014 4:56 am ]
Post subject:  error message

After completion of installation, to start precis I have got the following error message:

*** Installation complete ***

REMINDER: setvars has to be sourced before precis is run for the first time.
Source setvars with '. ~/setvars' before typing 'precis'
precis@linux-n2dl:~> . ~/setvars
precis@linux-n2dl:~> precis
wish8.3: error while loading shared libraries: libX11.so.6: cannot open shared object file: No such file or directory
precis@linux-n2dl:~>

if any one can help, please !!!.

Author:  dmhg [ Tue Nov 11, 2014 3:29 pm ]
Post subject:  Re: error message

Hi Girma,
What version of Linux are you using? Is it 32 bit Linux or 64 bit Linux?
Thanks
David

Author:  gkebede12 [ Tue Nov 11, 2014 9:31 pm ]
Post subject:  Re: error message

suse 12.3 64 bit Linux.

Girma

Author:  dmhg [ Wed Nov 12, 2014 5:50 am ]
Post subject:  Re: error message

Hi Girma,
This error usually comes about because PRECIS needs certain 32 bit libraries installed -- libraries which are not installed by default in 64 bit versions of Linux.

Assuming your laptop has internet access, try this command

Code:
sudo zypper install -t pattern 32bit



You can also try this, which should grab the specific package needed

Code:
sudo zypper install libX11-6-32bit


If you don't have internet access, open YaST package manager and do a search for libX11-6-32bit and then install it.

...and then try to open PRECIS again.
David

Author:  gkebede [ Tue Nov 18, 2014 3:59 pm ]
Post subject:  Re: error message

Thanks, Its solved.
Girma

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/