PRECIS support forum
http://forum.precisrcm.com/

PRECIS's simulation-NOT START
http://forum.precisrcm.com/viewtopic.php?f=1&t=118
Page 1 of 1

Author:  claudia.wanzeler [ Wed Nov 09, 2016 2:11 pm ]
Post subject:  PRECIS's simulation-NOT START

Dear Users,

I have successfully installed PRECIS2.0 on the Linux distribution openSUSE Leap. However, when I run the Default experiment, nothing happens. The display shows only the message "Not started" (As shown in the attached figure). I checked that only content was created in the umui_runs directory.
I tried to run different experiments, but appers the same message "Not started"

Any idea what's going wrong?

I appreciate any help.

All the best.


Claudia da Costa

Attachments:
imagen.jpeg
imagen.jpeg [ 234.76 KiB | Viewed 9225 times ]

Author:  saeed.sadri [ Fri Nov 11, 2016 9:26 am ]
Post subject:  Re: PRECIS's simulation-NOT START

Dear Claudia,
I am a new member of the support team and don't have an immediate answer for your problem but will consult with my colleagues and get back to you soon.

Regards,

Saeed

Author:  Simon W [ Fri Nov 11, 2016 12:00 pm ]
Post subject:  Re: PRECIS's simulation-NOT START

Can you try setting up a new region and rerunning?

Simon.

Author:  claudia.wanzeler [ Fri Nov 11, 2016 1:13 pm ]
Post subject:  Re: PRECIS's simulation-NOT START

Hello Saeed and Simon,

Thank you for your prompt reply.

I tried doing this with at least two different areas, however it did not work. The same message appears: NOT STARTED. :oops:

Claudia da Costa

Author:  Simon W [ Fri Nov 18, 2016 3:29 pm ]
Post subject:  Re: PRECIS's simulation-NOT START

Hi,

You may not have the "at" daemon turned on.

On the command line, can you type

at now

if you see something like:

warning: commands will be executed using /bin/sh
at>

hold down Ctrl and press "D"

If the message is like:

Can't open /var/run/atd.pid to signal atd. No atd running?

You'll need to turn on the at daemon. What short of linux are you using?

Author:  claudia.wanzeler [ Fri Nov 18, 2016 4:05 pm ]
Post subject:  Re: PRECIS's simulation-NOT START

Hello Simon,
I have taken all the steps you have recommended and have obtained the responses you posted.
I'm using the OpenSUSE Leap 42.1.

Claudia da Costa

Author:  dmhg [ Mon Nov 21, 2016 4:31 pm ]
Post subject:  Re: PRECIS's simulation-NOT START

Claudia,
TO install the at daemon, try

sudo zypper in at


You then can configure it to be enabled using Yast2 --> System Services (Runlevel).


David

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/