PRECIS support forum http://forum.precisrcm.com/ |
|
PRECIS's simulation-NOT START http://forum.precisrcm.com/viewtopic.php?f=1&t=118 |
Page 1 of 1 |
Author: | claudia.wanzeler [ Wed Nov 09, 2016 2:11 pm ] | ||
Post subject: | PRECIS's simulation-NOT START | ||
Dear Users, I have successfully installed PRECIS2.0 on the Linux distribution openSUSE Leap. However, when I run the Default experiment, nothing happens. The display shows only the message "Not started" (As shown in the attached figure). I checked that only content was created in the umui_runs directory. I tried to run different experiments, but appers the same message "Not started" Any idea what's going wrong? I appreciate any help. All the best. Claudia da Costa
|
Author: | saeed.sadri [ Fri Nov 11, 2016 9:26 am ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Dear Claudia, I am a new member of the support team and don't have an immediate answer for your problem but will consult with my colleagues and get back to you soon. Regards, Saeed |
Author: | Simon W [ Fri Nov 11, 2016 12:00 pm ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Can you try setting up a new region and rerunning? Simon. |
Author: | claudia.wanzeler [ Fri Nov 11, 2016 1:13 pm ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Hello Saeed and Simon, Thank you for your prompt reply. I tried doing this with at least two different areas, however it did not work. The same message appears: NOT STARTED. Claudia da Costa |
Author: | Simon W [ Fri Nov 18, 2016 3:29 pm ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Hi, You may not have the "at" daemon turned on. On the command line, can you type at now if you see something like: warning: commands will be executed using /bin/sh at> hold down Ctrl and press "D" If the message is like: Can't open /var/run/atd.pid to signal atd. No atd running? You'll need to turn on the at daemon. What short of linux are you using? |
Author: | claudia.wanzeler [ Fri Nov 18, 2016 4:05 pm ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Hello Simon, I have taken all the steps you have recommended and have obtained the responses you posted. I'm using the OpenSUSE Leap 42.1. Claudia da Costa |
Author: | dmhg [ Mon Nov 21, 2016 4:31 pm ] |
Post subject: | Re: PRECIS's simulation-NOT START |
Claudia, TO install the at daemon, try sudo zypper in at You then can configure it to be enabled using Yast2 --> System Services (Runlevel). David |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |